Teach you one minute mobile phone film


  Mobile phone film tutorial, once this trick comes out, it feels like the street vendor will be unemployed.

  If you are a detailed control, and your income is not very high, there is no frequent demand for replacement, or if you plan to sell second-hand later, it is more reliable to put a film on the screen. Because, this not only protects your love machine to a certain extent, but also sells one or two hundred yuan more when processing it.

  For friends in need, they generally don’t want to find hawker stickers on the flyover. On the one hand, they don’t have all kinds of stickers, and many of them are cut out with a cutter; on the other hand, their asking price is not cheap. How much will make people feel worthless. So, in the end, it is more cost-effective to post by yourself, but many users think that this is a technical job, and every time they post will fail.
In fact, sticking film is not difficult, as long as you master a few key steps, everyone can learn.

  As the saying goes: "Workers must first sharpen their tools if they want to do good things." Before starting work, we must first prepare some tools. Films, cleaning cloths, and cleaning fluids are essential. As for the role of hard cards and wide tape, I will introduce to you later, I will sell it here first.

  Wiping the screen is an important part of the preparation work. The cleaning fluid does not need to be sprayed too much. If it is too much, it will affect the efficiency of wiping the screen, and sometimes it will be contaminated with dust because the screen is too wet.

  In addition to the cleaning fluid, the method of wiping the screen also needs attention. If you drag it back and forth, it is difficult to clean the screen completely, and it is easy to leave traces of the cleaning fluid.

  Most of the current foils adopt a three-layer structure. Compared with the previous two-layer products, the three-layer foil greatly reduces the difficulty of operation and is more suitable for ordinary consumers without any experience.

  In addition to convenient operation, we can also tear off the A side and stick it on the screen to remove the dust. This is also a small trick.

  When doing this step, what is most needed is carefulness and patience, even for veterans, there will be deviations in position. No matter which direction you choose to start, you must compare carefully before starting.

  It doesn’t matter if you find the misalignment only after you paste it, just peel the B side up again, and then compare and paste it again. In this process, be careful not to let dust enter between the screen and the film.

  Since side A and side B are glued together, it is best to start from the corner when uncovering, first pry up one side, and then press side B with your fingers to remove the entire side A.
Basically every time you stick the film, you need to get rid of the bubbles, and the role of the hard card is this. Compared to handling bubbles with fingers, a flat hard card will make the film more uniform and more thorough.

   The step of catching bubbles is "large first and then small", first take care of the larger area, and the remaining small bubbles can be processed slowly. During the operation, try to rush towards the nearest edge, which can also shorten the "distance" and increase the success rate.
These "unstoppable" air bubbles cannot be solved by using a card. The reason is that some dust is contaminated inside, most of which are caused by negligence in operation. At this time, another auxiliary tool-wide tape is needed.
Generally, dust will be concentrated at the corners. At this time, you can use a hard card to slightly pry up the B side. Pay attention to the area not to be too large, so as not to cause more dust to enter.

   When pulling the tape, you can't force it in the horizontal direction. You need to detach the tape along the sticking place on the B side, otherwise the entire film will be pulled away.

  To sum up, the steps of mobile phone filming are mainly the following major points: 1. Clean the screen; 2. Correct the position of the film; 3. Correct, remove bubbles, and remove dust.

  In fact, just like doing other things, filming is a skillful job. Practice makes perfect. It is normal to use a few films at the beginning. After grasping a few key points, all that is left is carefulness and patience, and the details mentioned above also require more attention in operation. For novices, the last step is basically to hover between catching bubbles and clearing dust. After repeated operations a few times, the effect shown in the figure can be achieved.
 Finally, I want to say that it is not difficult to stick the film, but many people are unwilling to try, or subconsciously think that they will not stick well. In fact, just follow the steps above and post a few by yourself, a rookie can become a master of filming.